Answer

Mar 07, 2025 - 02:37 AM
To connect the TAJFUN 1000 Power Amplifier to your radio, you will need to follow these steps:
1. Connect the coaxial cable from your radio's RF OUTPUT to the RF INPUT jack on the rear panel of the TAJFUN 1000 Power Amplifier. Both connectors are N-female.
2. Attach the PTT RCA (CINCH) connector from your radio to the PTT input on the TAJFUN 1000 Power Amplifier. This will activate the broadcasting (Tx) mode when connected to GND.
3. Insert the supplied power cord into the POWER input on the TAJFUN 1000 Power Amplifier.
4. Turn on the power switch to initialize and start the control equipment.
Please note that if your device was transported or stored in a cool or cold environment, it is recommended to let it dry in a warm environment to prevent water condensation.
For more detailed instructions and information, please refer to the instruction manual provided with the TAJFUN 1000 Power Amplifier.
Add New Comment