User Manual Q&AAnswer
Mar 07, 2025 - 01:55 AM
To assemble the ASHLEY 2170306 Furniture Screen Time Power Recliner, follow these steps:
1. Start by checking all packing materials carefully for any loose parts that may have come during shipment. If any parts are missing, contact the retailer from which you purchased the product to obtain the missing parts.
2. It is recommended to assemble the unit with two or more people, as stated in the assembly instructions. This is to ensure safety and avoid any risk of injury.
3. Before starting assembly, make sure to read and understand all the safety instructions provided in the manual. These instructions include important warnings about the proper use and operation of the recliner.
4. Once you have unpacked the chair, locate the back wings (if included) and set them aside for installation later.
5. Find the hardware pack that contains the power transformer, power cord, and control wand. This pack is usually tied to the inside of the chair base. Carefully cut the ties and remove the pack.
6. Align the female brackets in the back of the chair with the male brackets in the chair base. Slide the back down onto the base and push down on the top of the back to lock it into position. You should hear a click from each side of the chair to ensure proper locking.
7. If your model has back wings, align the male and female brackets and slide the wings into place according to the labeled instructions.
8. Connect the power transformer cable to the corresponding plug coming from the back of the chair.
9. Connect the power cord to the power transformer.
10. Plug the power cord into an electrical outlet near where the chair will be used.
11. Before operating the chair, clear the area below it to reduce the risk of injury. If the chair is not functioning, check the plug-in and connection of the cords (A-B-C order) to ensure they are properly connected.
Please note that this answer is based on the information provided in the manual for the ASHLEY 2170306 Furniture Screen Time Power Recliner. It is always recommended to refer to the specific instructions and guidelines provided in the manual for accurate and safe assembly.
Add New Comment