Answer

Mar 07, 2025 - 12:52 AM
To connect the XD730.400 piezo objective scanner to the controller, please follow the installation steps provided in the user manual. Here are the steps:
1. Before installation, ensure the safety of the equipment by checking for any damaged cables or lack of grounding protection.
2. xxxx the corresponding objective lens into the XD730.400 piezo objective scanner and tighten it securely.
3. xxxx the lens into the adapter and tighten it.
4. Fix the installed piezo objective scanner and microscope connection section.
Note: During the installation process, handle the equipment carefully to avoid damaging the XD730.400 piezo objective scanner or causing scratches or wear.
Please make sure that the weight of the objective lens does not exceed the maximum allowable load of the XD730.400 scanner. The connection method of the LEMO connector is shown in the manual.
If you have any further questions or need additional assistance, please refer to the user manual or contact the customer service department of Coremorrow.
Add New Comment