Answer

Mar 07, 2025 - 12:51 AM
To use the Testboy Testavit Schuki 1 LCD Mains Outlet Tester, follow these steps:
1. Safety Precautions: Before using the tester, read the instruction manual thoroughly to understand the safety precautions and warnings. Ensure that you are familiar with the proper and intended use of the instrument.
2. Power Socket Test: The Testavit Schuki 1 LCD can be used to check the correct connection and wiring errors in sockets. The connection status is indicated by LEDs and can be determined using the printed table. If an impermissible high contact voltage is applied at the protective earth connection, the finger contact must be touched, and if the LCD display illuminates, there is an error.
3. FI/RCD Test: By activating the "FI/RCD test" button for less than 3 seconds, you can perform a function check of the residual current device (30 mA / 230 V AC). It is important to note that this test should only be done on fixed installations and constructions. Testing movable appliances or extensions could lead to a high current flow through the protective earth-connected metal parts.
4. Operating and Display Elements: The tester has status LEDs, an LC display, a finger contact, and a button. The status LEDs indicate the test results, and the LC display provides additional information. When contacting the finger, ensure sufficient contact with the earthing potential to avoid incorrect indications.
5. Precautions and Recommendations: Before testing, disconnect any loads from the circuits of all socket outlets in the same distribution board as the one under test. Check the RCD trigger function in a known correct circuit with RCD before use. Be cautious with voltages above 30 V AC as there may be a shock hazard.
Please note that this answer provides a general overview of how to use the Testboy Testavit Schuki 1 LCD Mains Outlet Tester. For detailed instructions and specific safety guidelines, refer to the instruction manual provided with the product.
Add New Comment