User Manual Q&AAnswer
Mar 07, 2025 - 12:30 AM
To program the TFC Group WFSTAT Wi-Fi Thermostat using the touch controls, follow these steps:
1. Press the SET icon briefly to choose between Program mode (PRG) or manual mode (sun symbol). In program mode, the thermostat will run the programmed time and temperature sequence.
2. To adjust the set temperature temporarily, while in program mode, touch the UP or DOWN arrows. The display will change from showing 'ROOM' and the current measured temperature to showing 'SET' and the temperature you are setting. After five seconds, the thermostat will time-out and show 'ROOM' and the measured temperature again. The heating will be switched on or off according to the adjustment you made. The programmed time/temperature setting will be restored with the next program entry in the memory.
3. To review or change the factory pre-set program, touch the PROG icon for 5 seconds. The display will show the first program. Confirm the time by touching the PROG icon again or change it in 15-minute increments by touching the UP or DOWN arrows. Confirm by pressing the PROG icon. Then, you will be viewing the temperature. Confirm by pressing the PROG icon again or change the value in 0.5°C steps using the UP or DOWN arrows. Touch PROG to confirm. You can continue to view and modify the other time/temperature programs in the same way.
4. If you want to create your own program, you must overwrite the pre-set sequence. It is recommended to write down your desired program first. After programming, you can touch the ON/OFF or 'Back' icons to save and quit. If you change a temperature value during the current program period while programming, you can apply the changed temperature immediately after quitting programming by touching SET, waiting for 30 seconds, and then touching PROG.
Please refer to the TFC Group WFSTAT Wi-Fi Thermostat instructions for more detailed information and programming examples.
Add New Comment