User Manual Q&AAnswer
Mar 06, 2025 - 10:58 PM
To install the ENABLING TECHNOLOGIES Dynamique Seat Mounting Standardization Kit, follow these steps:
1. Remove the Seat Liner from the Seat.
2. Unfasten the two sidewalk bolts at the rear of the Seat using a #2 Phillips screwdriver. Discard these bolts.
3. Unfasten the two 1/4-20 x 1 7/8" button head bolts at the Seat Dump Bracket. Shift the ski into the “Up” position for better access to the bolts. Save these bolts for reuse.
4. Remove the Seat from the Frame. If your ski does not have a Seat Pivot Repair Kit installed, do not proceed. Refer to the separate "Seat Pivot Recall Notice & Repair Kit" manual and contact the company.
5. Remove the Repair Kit from the frame by hitting the tabs on the ends. Discard the Repair Kit.
6. Slide the Standardization Kit over the Seat Pivot, ensuring that the side with the rivnuts is against the Skid Plate. The kit is labeled "bottom."
7. Align the holes in the Repair Channel with the rivnuts in the Seat Pivot and check the range of rotation. You may need to use a rubber mallet to fully align the Repair Channel. If the tabs on the Repair Channel interfere with the welds on the frame, you can file the ends of the tabs down.
8. Fasten the new 1/4-20 x 1 1/4 flat head screws to the 8” wide rivnuts in the frame using a 5/32” Allen Wrench and Locktite Red. These bolts should not be removed in the future.
9. Use the Standardization Kit as a guide to drill holes at 6” wide through the frame's Seat Pivot using a 5/16” bit. Be careful and drill only through the frame's Seat Pivot, avoiding the rivnuts below on the Standardization Kit.
10. Use the included template to drill new rear mounting holes in the Co-Poly seat at 6” wide. Fasten the drill template to the original 8” wide holes in the Co-Poly seat using the provided 1/4-20 x 3/4” side walk bolts and 1/4-20 wing nuts. Drill two new holes in the Co-Poly seat at 6” wide using an F (0.257”) size bit. Remove the drill template from the seat.
11. Reinstall the Seat by loosely fastening it down to the 6” wide rivnuts on the underside of the Standardization Kit using the new 1/4-20 x 1 3/4” pan head bolts. Only use these bolts to mount a seat to this frame from now on. Fasten the Seat Dump Bracket to the frame using the original 1/4-20 x 1 7/8” button head screws removed in Step 2. Adjust the Seat Dump Bracket along the slots if necessary.
12. Finish tightening the two new pan head bolts at the rear of the seat.
13. Reinstall the Seat Liner.
14. The installation is now complete. Moving forward, it is recommended to inspect the Seat Pivot and Standardization Kit during periodic maintenance.
For more information or assistance, you can contact ENABLING TECHNOLOGIES at 303.578.9345 or email info@enablingtech.com.
Add New Comment