User Manual Q&AAnswer
Mar 06, 2025 - 10:13 PM
To install the , follow these steps:
1. Check for regional and local installing/mounting requirements.
2. Align the bracket to the local ADA requirement distance from the floor plus 2 5/8" (7 cm) to ensure the bottom of the dispenser is at the correct ADA height. Make sure the built-in level on the bracket reads level.
3. Ensure the required clearance space is free of obstructions for proper dispenser installation.
4. Carefully brace the mounting bracket in place once it is properly located on the wall and mark holes to drill.
5. Remove the bracket from the wall, leaving just the four marked holes. Drill a hole in each of the four marked locations so anchors can be inserted.
6. Tap in the four anchors in each drilled hole so the bracket can be screwed to the wall.
7. Bring back the mounting bracket and insert a xxxx into each wall anchor to secure the mounting bracket to the wall. xxxx the mounting bracket to the wall starting with the marked anchor hole. Make sure not to over-tighten the xxxx and damage the bracket!
8. Ensure that proper mounting hardware is used for appropriate wall composition as enclosed hardware may not be compatible with your wall surface.
9. Carefully line the mounted wall bracket up to the rear, corresponding bracket pocket of the dispenser backplate to complete installation.
10. Once the mounting bracket is in its designated, corresponding pocket, lower the dispenser backplate until the lock button clicks.
11. Fasten the security xxxx to completely secure the dispenser to the mounting bracket. Do not over-tighten the security xxxx !
For more detailed instructions and illustrations, please refer to the user guide available at www.kcprofessional.com.
Add New Comment