Answer

Mar 06, 2025 - 10:03 PM
Installation of the welldana PZA-WTM-S Wall Penetration with Flange Kit involves the following steps:
1. Prepare the wall: Determine the location where you want to install the wall penetration. Ensure that the wall is clean and free from any debris or obstructions.
2. Mark the hole: Use the provided template or measure the diameter of the flange to mark the hole on the wall. Ensure that the hole is centered and level.
3. Drill the hole: Use a suitable drill bit to drill the hole according to the marked diameter. Be cautious of any electrical wiring or plumbing behind the wall.
4. Insert the thinwall wall conduit: Insert the thinwall wall conduit into the drilled hole, making sure it extends evenly on both sides of the wall.
5. Secure the wall conduit: Place the silicone gasket wall on the outer side of the wall, aligning it with the thinwall wall conduit. Secure it in place using the wall conduit nut.
6. Attach the flange: Slide the liner ring over the thinwall wall conduit from the inner side of the wall. Then, attach the flange to the liner ring using the provided screws. Ensure that the flange is tightly secured to the wall.
7. Install the tail piece: Insert the tail piece into the thinwall wall conduit from the inner side of the wall. Secure it in place using the hexagon nut.
8. Apply silicone gasket liner: Apply the silicone gasket liner around the tail piece on the inner side of the wall. This will provide a watertight seal.
9. Connect the plumbing: Connect the plumbing or piping to the tail piece, ensuring a proper and secure connection.
10. Seal the outer side: Apply a suitable sealant or silicone rubber around the outer side of the flange to further ensure a watertight seal.
11. Complete the installation: Tighten the plastic nut 1 onto the tail piece from the outer side of the wall. Then, insert the silicon plug into the thinwall wall conduit to prevent any debris from entering.
12. Optional: If using a flex tube, attach it to the tail piece using the plastic ring and plastic nut 2.
Please note that the provided instructions are a general guide. It is important to refer to the specific instructions provided with the welldana PZA-WTM-S Wall Penetration with Flange Kit for accurate installation steps and any additional considerations.
Add New Comment