User Manual Q&AAnswer
Mar 06, 2025 - 08:58 PM
To install the Juniper MX304 router in a rack, follow these steps:
1. Ensure that the rack is strong enough to support the router's weight and is adequately supported at the installation site.
2. Wrap and fasten one end of the electrostatic discharge (ESD) grounding strap around your bare wrist, and connect the other end to a site ESD point.
3. (Optional) Install the cable management brackets on each side of the front of the chassis.
4. Position the router in front of the four-post rack or cabinet.
5. With one person holding on to each side of the chassis, carefully lift the bottom of the chassis so that the rack mounting brackets contact the rack rails.
6. Attach the chassis to the front of the rack using the provided screws.
7. On the rear of the chassis, slide the rear-mounting brackets on both sides of the chassis until they contact the rack rails. Insert the rack mounting screws through the mounting brackets and mounting holes on the rack, and tighten them.
8. Verify that the mounting brackets on each side of the rack are level.
9. (Optional) Secure the front cover with the air filter to the chassis using the provided screws.
For more detailed instructions and illustrations, please refer to the "Install the MX304 Router in a Four-Post Rack" section of the JUNIPER MX304 Day One+ Universal Routing Platform Instruction Manual.
Add New Comment