Answer

Mar 06, 2025 - 08:43 PM
To install the STAHL 254810 Earth Tags, please follow the steps below:
1. Ensure that the equipment or device you are installing the Earth Tags on is powered off and disconnected from any power source.
2. Identify the suitable location on the equipment where the Earth Tags need to be installed. It is recommended to consult the equipment manufacturer's guidelines or relevant safety standards for proper placement.
3. Clean the surface of the equipment where the Earth Tags will be attached to ensure good electrical contact. Remove any dirt, grease, or corrosion.
4. Take the Earth Tag and align the threaded portion (outer diameter) with the corresponding threaded hole on the equipment. The Earth Tag has an M63 thread (outer).
5. Insert the Earth Tag into the threaded hole and rotate it clockwise until it is securely tightened. Ensure that it is firmly in place.
6. Once the Earth Tag is installed, connect the other end of the Earth Tag to a suitable grounding point. This can be a grounding terminal, grounding bus, or any other designated grounding point as per the equipment's grounding system.
7. Verify the proper installation of the Earth Tags by conducting a visual inspection and checking for secure attachment and proper electrical continuity.
Please note that the above instructions are a general guideline for installing Earth Tags. It is always recommended to refer to the equipment manufacturer's guidelines and relevant safety standards for specific installation requirements and procedures.
Add New Comment