Answer

Mar 06, 2025 - 07:57 PM
To install the Ciarra CBCS6903, CBCB6903 60cm Slim Cooker Hood in extraction mode, follow these steps:
1. Remove all protective poly film from the hood and its parts.
2. Determine the recommended installation height for best extraction, which is 25.6"~29.5" above the cooktop.
3. For gas hobs, the required height over the hood is 29.5", and for electric hobs, it is 25.6".
4. Install the outlet cover on the circular air outlet at the back of the cooker hood.
5. According to the provided 1:1 hole drawing, drill four Ø0.31" holes on the wall. Install wall plugs if necessary.
6. Insert the upper two wall plugs with 0.16"*1.18" screws, leaving a gap of no less than 0.2".
7. Place the range hood onto the top two screws and lock them tight with self-tapping screws.
8. Lock the lower two holes with 0.16"*1.18" screws.
9. Connect the ductwork to the hood using metal foil duct tape to secure and make the joints airtight.
10. Make sure the damper assembly or round duct plate enters the ductwork and that the damper opens and closes freely.
Note: The installation instructions may vary depending on the specific model and configuration of the cooker hood. It is always recommended to refer to the user manual provided with the product for detailed instructions and illustrations.
Add New Comment