User Manual Q&AAnswer
Mar 06, 2025 - 06:58 PM
To install the ELSYS EMS Wireless Sensor, follow these steps:
1. Remove the back panel of the sensor using a small screwdriver.
2. Install the battery. The EMS requires one AA battery (3.6V Lithium Battery ER14505).
Caution: Only use the provided battery type to avoid performance loss and damage to the device. Dispose of the battery properly.
3. Mount the back panel on the desired surface using the adhesive tape.
4. Attach the cover to the back panel.
For specific installation instructions for different sensor functions:
- Door activity sensor: Mount the magnet part on the door and the sensor part on the frame. For double doors, use one part on each door.
- Water leak sensor: Mount the back panel on the surface where water may leak. The sensor element that detects the leak is placed on the back panel.
- Temperature/humidity sensor: Place the device on a wall, under a desk, or any flat surface. Avoid direct sunlight and placement near air vents.
For more detailed information, refer to the "Installation" section of the ELSYS EMS Wireless Sensor User Manual.
Add New Comment