User Manual Q&AAnswer
Mar 06, 2025 - 06:10 PM
To install the STAHL 9494 Series is1+ Bus Rail, follow these steps:
1. Assemble the DIN rail.
2. Place the "BusRail Begin" termination onto the DIN rail and fasten it with a mounting xxxx .
3. Insert the BusRail part into the DIN rail and push it until it reaches the "BusRail Begin" termination.
4. Clamp the ground clamps onto the DIN rail.
5. If necessary, insert additional BusRail parts and push them until they latch in place.
6. Clamp the ground clamps onto the DIN rail.
7. If needed, assemble further BusRail parts until the desired length is achieved.
8. Place the "BusRail End" termination on the DIN rail and fasten it with a mounting xxxx .
Note: If you are installing the BusRail on two rails, follow the same steps but use two DIN rails and connect them with the connection cable terminations.
For more detailed instructions and illustrations, please refer to the "Mounting and installation" section of the STAHL 9494 Series is1+ Bus Rail User Manual.
Add New Comment