Answer

Mar 06, 2025 - 02:59 AM
To mount the HINKLEY 5050 Miley Single Light Vanity fixture, follow these steps:
1. Prepare the mounting strap (A) by threading the two long mounting screws (B) into the back of the gull-wing bracket.
2. Ensure that the holes into which the screws are threaded match the spacing of holes (D) in the back plate (E).
3. Attach the mounting strap (A) to the junction box (J) using two 1" screws (C) (not provided).
4. Make sure to read the wiring and grounding instructions (I.S. 18) and any additional directions before proceeding with the installation. Turn off the power supply during installation.
5. Make the necessary electrical connections from the supply wire to the fixture lead wires, following the instructions provided in the instruction sheet (I.S. 18).
6. Slide the backplate (E) over the screws (B) and secure it with the ball knobs (F).
7. To install the glass, remove the spacer (3) and socket ring (4) from the socket (1).
8. Place the glass (2) over the socket (1).
9. Slip the spacer (3) and thread the socket ring (4) back onto the socket (1) and hand tighten. Be careful not to over-tighten, as it could cause damage to the glass.
10. The fixture is now ready to be lamped according to your preference.
Please note that it is important to read and follow all safety warnings and instructions provided in the manual. If you are unsure or uncomfortable with any step of the installation process, it is recommended to consult a qualified electrician or local authorities for assistance.
Add New Comment