How do I program the BEOK BOT-R315 RF GasBolier Programmable Thermostat? (BEOK BOT-R315 RF GasBolier thermostat Instruction Manual)

Answer

manuals.plus

Mar 06, 2025 - 02:56 AM

To program the BEOK BOT-R315 RF GasBolier Programmable Thermostat, follow these steps:

1. Synchronizing Clock: Press the button to switch off the thermostat, and then press and hold the M button for 3 seconds. Adjust the clock from Minute, Second, and Weekday via the buttons.

2. Setting Time Zones: There are 4 Time Zones in total. Press and hold the button for 3 seconds, it will display 4 and Monday. Adjust the numbers (1 to 4) of Time Zones via the buttons. Press shortly to enter into Automatic Mode Settings of each Time Period and relative Setpoint. Sequence is from Hour (1st time zone), Minute (1st time zone), and Setpoint (1st time zone) to Hour (4th time zone), Minute (4th time zone), and Setpoint (4th time zone). After settings of Monday is done, press shortly and switch over from Tuesday to Sunday, following the same setting steps as above.

3. Temperature and Mode Settings: Press shortly to select Comfort Mode, Energy Saving Mode, Holiday Mode, Automatic Mode, and Manual Mode (Overridden Mode).

4. Parameters Setting: Press the button to switch off the thermostat, and then press and hold the button for 3 seconds. Use the buttons to select and adjust the following parameters:
- D1 Diff. Temp of Switch On/Switch off: Set the temperature difference for the thermostat to switch on or switch off.
- D2 Temperature Calibration: Adjust the temperature calibration by -4℃ to +4℃.
- D3 Frost Protection: Set the temperature range for frost protection.

5. RF IP Learning: If you need to pair the transmitter and receiver, follow the steps below:
- Press and hold the RF Connection button on the receiver until LED 2 is flashing in green rapidly.
- Switch off the thermostat, and press and hold the thermostat's ON/OFF button for 3 seconds until the menu setting appears.
- Switch to the d6 settings via the ON/OFF button, and then press on the thermostat to confirm the connection. Switch on the thermostat, and the green LED 2 on the receiver will turn off completely.

For more detailed instructions and information, please refer to the BEOK BOT-R315 RF GasBolier Programmable Thermostat Instruction Manual.