Answer

Mar 06, 2025 - 02:24 AM
To connect the Samsung SWA-9200S wireless rear speaker kit to your soundbar, please follow these steps:
1. Connect the surround speaker cables: Use the speaker cables provided to connect the two surround sound speakers. Insert the red and black colored ends of each speaker cable into the red and black jacks of the appropriate speaker. Make sure to insert the wire fully, taking care not to insert beyond the wire insulation.
2. Turn on the surround speakers: Plug the surround speakers' power cord into an electrical outlet to turn them on. The LINK LED indicator (blue LED) on the rear of the left surround speaker should blink quickly. If the LINK LED does not blink, please refer to the troubleshooting section in the manual.
3. Turn off the soundbar: If your soundbar is turned on, please turn it off by pressing the power button on the soundbar or remote control.
4. Connect the soundbar and surround speakers: Press and hold the Up button on the remote control for more than 5 seconds until the "ID SET" message appears on the soundbar's display. The message will disappear shortly. After the ID SET process is successful, the soundbar will turn on automatically.
5. Check the connection: The LINK LED on the surround speakers should stop blinking and change to solid blue when the soundbar and surround speakers are successfully linked. Please turn off the soundbar and turn it back on to confirm that the LINK LED is blue. If the LINK LED does not turn to solid blue, please refer to the troubleshooting section in the manual.
Please note that the above steps are a general guide, and the specific instructions may vary depending on your soundbar model. For more detailed information, please refer to the user manual provided with your Samsung SWA-9200S wireless rear speaker kit.
Source: To connect the Samsung SWA-9200S wireless rear speaker kit to your soundbar, please follow these steps: 1. Connect the surround speaker cables: Use the speaker cables provided to connect the two surround sound speakers. Insert the red and black colored ends of each speaker cable into the red and bl
Add New Comment