How do I install the Sinope RM3500ZB Smart Water Heater Controller? (sinope RM3500ZB Water Heater Controller Installation Guide)

Answer

manuals.plus

Mar 06, 2025 - 02:03 AM

To install the Sinope RM3500ZB Smart Water Heater Controller, follow these steps:

1. Ensure that the installation is done by a certified electrician and in accordance with national and local electrical codes. The controller is designed for indoor use only.

2. Turn off the water heater circuit at the main electrical panel.

3. Gather the necessary hardware for installation, including a standard utility electrical wiring box (4’’ x 4’’ x 1-1/2»’ deep) with conduit knockouts, an electrical box cover, and two wire clamps.

4. Insert the water heater wire (load) and the power wire (line) into the electrical box and secure them with wire clamps.

5. Install an electrical box ground wire to the water heater ground xxxx .

6. Install the temperature probe by unscrewing and removing the door plate located at the top of the water heater. Plug the probe into the controller’s temperature port. Remove the sticker liner from the end of the probe and affix it to either side of the water heater’s thermostat. xxxx the water heater door plate back in place.

7. (Optional) If you have the AC4200C-02 water detection cable, plug it into the controller’s lower port. Position the water detection cable at the base of the water heater and secure its position with the provided fasteners.

8. Power up the controller.

To add the controller to the Neviweb app:

1. If you don't have an account yet, download the Neviweb app for iOS or Android and create an account.

2. Tap the "+" button and select "Add Device".

3. Follow the steps of the installation wizard.

To connect the controller to the GT130 gateway or a compatible Zigbee system:

1. Initiate the connectivity session by pressing the RF signal button on the GT130 gateway. The indicator light will start flashing.

2. Press the ON/OFF button on the controller for 3 seconds to connect it to your network.

3. When all your devices are connected, close the connectivity session of your GT130 gateway or your compatible Zigbee gateway.

Please note that these instructions are a summary, and it is important to refer to the Sinope RM3500ZB Smart Water Heater Controller Installation Guide for complete and accurate information.