User Manual Q&AAnswer
Mar 06, 2025 - 01:38 AM
To set up the UHD HDMI 2.0 Video Format Conversion Design Example on the Intel Arria 10 FPGA development board, follow these steps:
1. Fit the Bitec HDMI 2.0 FMC card to the Intel Arria 10 GX FPGA development board using FMC Port A.
2. Ensure the power switch (SW1) is turned off, then connect the power connector.
3. Connect a USB Blaster II download cable to your computer and to the MicroUSB Connector (J3) on the Intel Arria 10 GX FPGA development board.
4. Attach an HDMI 2.0 cable between the HDMI video source and the Rx port of the Bitec HDMI 2.0 FMC card and ensure the source is active.
5. Attach an HDMI 2.0 cable between the HDMI display and the Tx port of the Bitec HDMI 2.0 FMC card and ensure the display is active.
6. Turn on the board using SW1.
Please refer to the "Setting up the Intel Arria 10 FPGA development board" section in the user guide for more detailed instructions and illustrations.
Note: Make sure you have the required hardware and software as mentioned in the "Hardware and Software Requirements for the UHD HDMI 2.0 Video Format Conversion Design Example" section of the user guide.
Add New Comment