User Manual Q&AAnswer
Mar 06, 2025 - 01:25 AM
To install the FISHER PAYKEL AHV2-RF36DD36 Professional Square Handle Kit for Integrated Cool Drawer, please follow the steps below:
1. Ensure that you have the necessary tools for installation, including a screwdriver and measuring tape.
2. Start by removing any existing handles or hardware from the integrated cool drawer.
3. Measure and mark the desired height for the handle on the door panel or cabinetry panel. The height should be 1 3/8 inches from the bottom edge of the panel.
4. Measure and mark the center point of the panel's width. This should be 17 1/8 inches from either side of the panel.
5. Align the handle with the marked center point and height on the panel.
6. Using the provided screws, attach the handle to the panel. Make sure to tighten the screws securely.
7. Repeat the process for the other side of the panel if you are installing a pair of handles.
8. Once the handles are securely attached, carefully align the panel with the integrated cool drawer and attach it according to the instructions provided with the cool drawer.
Please note that these instructions are a general guide and may vary depending on your specific model. It is always recommended to refer to the user guide or contact Fisher & Paykel's Customer Care Centre for any specific installation instructions or assistance.
Add New Comment