User Manual Q&AAnswer
Mar 06, 2025 - 12:46 AM
If you need to adjust the hinges on the WYNDHAM COLLECTION WC-1111-42-SGL Single Bath Vanity Cabinet, follow these steps:
1. Start by removing the cabinet doors from the hinges. This can usually be done by unscrewing the hinges from the cabinet frame.
2. Once the doors are removed, locate the adjustment screws on the hinges. These screws are typically located on the side or back of the hinge.
3. To adjust the doors vertically (up and down), use a screwdriver to turn the vertical adjustment xxxx clockwise to raise the door or counterclockwise to lower the door. Make small adjustments and test the door alignment after each adjustment.
4. To adjust the doors horizontally (left and right), use a screwdriver to turn the horizontal adjustment xxxx clockwise to move the door towards the center or counterclockwise to move the door away from the center. Again, make small adjustments and test the door alignment after each adjustment.
5. Once you have achieved the desired alignment, reattach the doors to the hinges by screwing them back onto the cabinet frame.
Please note that professional installation is recommended for the WYNDHAM COLLECTION WC-1111-42-SGL Single Bath Vanity Cabinet. If you are unsure about adjusting the hinges yourself, it is best to seek the assistance of a professional.
Add New Comment