User Manual Q&AAnswer
Mar 06, 2025 - 12:40 AM
Sure! Here are the step-by-step instructions for installing the Select Blinds Designer Double Cell Blackout Honeycomb Shades:
Inside/Ceiling Mount:
1. Place the shade in the desired location and mark the front edge.
2. Measure 3" in from the shade edge on both ends and mark.
3. Mark the xxxx locations and center additional brackets if needed.
4. Position the brackets 5⁄16" from the window casing for a flush mount.
5. Drill holes at the marked locations.
6. xxxx the brackets into place.
7. Mount the shade into the brackets.
8. Attach the cordless lift handle(s).
For shades up to 24" wide, clip a handle centered on the bottom rail without pinching the fabric or slats. For larger shades, attach two handles spaced evenly as far apart as you can comfortably reach. To lower the shade, use the handle(s) to pull down. To raise the shade, use the handle(s) to lift up. The same procedure applies for bottom-up/top-down shades.
Outside Mount:
1. Place the shade in the desired location and mark the corners.
2. Measure 3" in from the shade edge on both ends and mark.
3. Mark the xxxx locations and center additional brackets if needed.
4. Drill holes at the marked locations.
5. xxxx the brackets into place.
6. Mount the shade into the brackets.
7. Attach the cordless lift handle(s).
Optional Extension Bracket:
If you need to extend the shade further from the wall, you can use the optional extension brackets. Follow the same steps as the outside mount installation, but use the extension brackets instead of the regular brackets.
Optional Hold-Down Brackets:
If you want to secure the bottom of the shade in place, you can use the optional hold-down brackets. Install them according to the instructions provided in the manual.
Optional Side Mount:
If your shade is 60" or less in width, you can use optional side mounts for a flush mount. Assemble the brackets and measure the distance from the window casing to the front of the bracket based on the shade type (3⁄8" Single Cell: 13⁄8", 1" Pleated Shades: 15⁄8", 3⁄4" Single Cell/1⁄2" Double Cell/2" Pleated Shades: 15⁄8", 11⁄4" Single Cell Shade: 23⁄8"). Install the side mounts accordingly.
Please refer to the provided diagram and instructions in the manual for a visual representation of the installation process.
Add New Comment