User Manual Q&AAnswer
Mar 06, 2025 - 12:23 AM
To assemble the E2-02-SS E2 CONNEX Dynamic Dual, follow these steps:
1. Secure the Top Down Mount (A) to the worksurface according to the instructions on page 14 of the manual.
2. Insert and secure the Pole (C) into the mount (A) as described on page 16.
3. Slide the Dual Yoke (F) over the pole and secure it at the desired height using the 3/32" Hex Key (V) with a torque of 30 in-lbs. Refer to page 17 for more details.
4. Insert two 8" Extensions (K1) with Rotational Stop Slot to the Dual Yoke (F) and secure them with Dog Washer (R) and xxxx (S).
5. Insert two 8" Extensions (K) into the 8" Extensions (K1) with Rotational Stop Slot. Secure them with Dog Washer (R) and xxxx (S).
6. Insert two Sliders (M) to the 8" Extensions (K) and secure them with Dog Washer (R) and xxxx (S). See page 18 for instructions.
7. Attach Quick Connect VESA Plates (N) to the monitors using Screws (T) and insert them into the Sliders (M). Refer to page 18 for more details.
8. Snap the Cable Clip (Q) onto the Pole (C).
Please note that this is a general overview of the assembly process. For more detailed instructions and illustrations, refer to the Innovative E2-02-SS E2 CONNEX Dynamic Dual Instruction Manual.
Add New Comment