Answer

Mar 06, 2025 - 12:20 AM
To install the FRICO SWX CS-D Hot Water Air Heater Unit, follow these steps:
1. Fitting the wall bracket:
- Remove the eight screws indicated in picture A.
- Install the brackets with the holes facing the fan motor, as shown in picture B.
- Make sure the wall is able to support the weight of the fan heater.
2. Mounting the fan heater:
- The fan heater can be mounted with the connection pipes facing left or right.
- If mounting on the ceiling for a vertical air stream, follow the instructions in photo D.
- Ensure the minimum distance to the wall or corner is maintained as specified in the manual.
- Make sure the ceiling is able to support the weight of the fan heater.
3. Connection of heating coil:
- The installation must be carried out by an authorized installer.
- Connect the water supply pipe to the lower pipe on the heater and the outlet pipe to the upper pipe, as shown by the arrows in picture E.
- Use R3/4" connections.
- Ensure careful connection to prevent pipe damage and water leakage.
- The heating coil must not be connected to a mains pressure water system or an open water system.
- Ventilate the pipe system before use and install an air valve on a high point in the pipe system.
- Units exposed to air temperatures below zero should have external frost protection.
4. Electrical installation:
- The electrical installation should be carried out by a qualified electrician in conformity with prevailing regulations.
- Supply the appliance via a triple-pole switch with at least 3 mm breaking gap.
- Check the rotation of the fan after electrical installation.
Please refer to the manual for detailed instructions, including wiring diagrams and maintenance guidelines.
Add New Comment