Answer

Mar 05, 2025 - 09:31 PM
Sure! Here's a step-by-step guide on how to install the QSTARZ LT-8000GT External GPS Antenna:
1. Start by locating the rubber cover on the back of the LT-8000GT device. This cover protects the antenna jack.
2. Open the rubber cover by gently pulling it upwards or sideways, depending on the design of your device.
3. Take the GPS antenna connector and align it with the antenna jack on the LT-8000GT. The connector should be inserted vertically into the jack.
4. Push the connector firmly into the jack until it is fully inserted. Make sure it is securely connected.
5. When you need to remove the external antenna, hold the connector and unplug it vertically. This will prevent any damage to the connector or the device.
6. To close the rubber cover, start by pushing down the top part of the cover into the antenna jack. Then, push down the bottom part of the cover until it is fully closed.
Please refer to the manual provided with your QSTARZ LT-8000GT External GPS Antenna for any additional information or troubleshooting tips.
Add New Comment