Answer

Mar 05, 2025 - 08:38 PM
To configure the network for the JBT EW020 Control Box, please follow these steps:
1. Turn on your phone's Bluetooth and connect it to a 2.4GHz Wi-Fi network.
2. Press and hold the switch button on the control box for 3 seconds or switch it on and off three times (on-0.5S off-0.5S on-0.5S off-on). This will make the flood light flash quickly (2 times/second).
3. Open the Smart Life APP on your phone and log in.
4. Click the add icon in the upper right corner of the app.
5. Click on "Auto Discovery" and the app will automatically search for devices.
6. Once the addition is successful, click "Finish" to jump to the control page.
Additionally, the manual mentions four other distribution network modes for the product:
1. APP pop-up window distribution network: After powering on the device, open the app interface, and a pop-up window will appear to guide you through the device network connection.
2. Bluetooth manual add: Power on the device and quickly open the app's add device interface. Manually search for the device to establish a Bluetooth connection.
3. EZ distribution network: Power on the device and open the app's add device interface. Manually add a Wi-Fi device and select EZ mode for network distribution.
4. AP distribution network: Power on the device and press and hold the power button for 5 seconds until the indicator light flashes slowly. Open the app's add device interface and manually add a Wi-Fi device. Select EZ mode and connect to the network when the indicator light flashes slowly (once every 2 seconds).
Please note that these instructions are based on the information provided in the manual for the JBT EW020 Control Box.
Add New Comment