User Manual Q&AAnswer
Mar 05, 2025 - 07:54 PM
To bind the Lumary QB110-24BT-09 remote control to your devices, please follow these steps:
1. Make sure the device is added to the application with the network first.
2. Reboot the device once through the physical switch. The device will enter configuration mode within 30 seconds.
3. Long press the desired group button (e.g., Group A) on the remote control until the lamps start blinking. This indicates that the lights have been configured.
4. If the lights do not blink during the configuration process, you need to re-long press the group button until all devices are bound. If the timeout occurs, you can repeat the above operation.
5. Repeat the same binding process for other groups if needed.
Note: Remember to press the group button first when you want to control a specific group. Then, use the brightness, color temperature, color light, or scene buttons to control the desired function.
If you encounter any issues or have further questions, please contact Lumary support at support@lumary.tech. They will provide guidance and instructions to assist you.
Add New Comment