Answer

Mar 05, 2025 - 07:27 PM
To install the welldana PZA-WTM-S Wall Conduits, follow these steps:
1. Start by gathering all the necessary components: Screws (6), Liner ring, Silicone gasket liner, Thinwall wall conduit, Silicone gasket wall, Wall conduit nut, Tailpiece, Hexagon nut, Silicon rubber, Plastic nut 1, Silicon plug, Plastic ring, Plastic nut 2, Flex tube, and Teflon tape.
2. Begin by attaching the liner ring to the thinwall wall conduit. Make sure it fits securely.
3. Apply Teflon tape to the threads of the wall conduit nut.
4. Insert the thinwall wall conduit into the desired location on the wall, ensuring it is aligned properly.
5. Secure the thinwall wall conduit by tightening the wall conduit nut onto the threads. Use a wrench or pliers to ensure it is tightened securely.
6. Attach the silicone gasket wall to the thinwall wall conduit. Ensure it is fitted properly.
7. Insert the tailpiece into the thinwall wall conduit, making sure it is aligned correctly.
8. Secure the tailpiece by tightening the hexagon nut onto the threads. Use a wrench or pliers to ensure it is tightened securely.
9. Apply silicone rubber to the outer edge of the plastic nut 1.
10. Attach plastic nut 1 to the tailpiece, ensuring it is fitted properly.
11. Insert the silicon plug into the tailpiece, sealing it securely.
12. Attach the plastic ring to the tailpiece, ensuring it is fitted properly.
13. Apply silicone rubber to the outer edge of the plastic nut 2.
14. Attach plastic nut 2 to the tailpiece, ensuring it is fitted properly.
15. Attach the flex tube to the tailpiece, making sure it is connected securely.
16. Finally, check all connections to ensure they are tight and secure.
Please note that this is a general installation guide. For specific instructions and any additional information, it is always recommended to refer to the official welldana PZA-WTM-S Wall Conduits installation manual.
Add New Comment