User Manual Q&AAnswer
Mar 05, 2025 - 04:28 AM
Sure! Here are step-by-step instructions on how to make a button using the Mophorn Button Maker:
1. Start by using the die cutter to cut out your artwork. Make sure the artwork is the appropriate size for your button.
2. Gather the button components: shell, artwork, Mylar, and pin back.
3. Place the components into the button maker. In the left die, load the components in the following order: shell (smooth side up), artwork, and Mylar. Make sure the artwork and Mylar are lying flat on top of the shell.
4. Insert the pin back into the right die. Pay attention to the orientation of the pin. The holes on the pin back should be horizontal and below center.
5. Rotate the left die clockwise and pull down the red handle with some force. This action will pick up the components and they will stay in the upper die.
6. Rotate the dies counterclockwise so that the pin back is now under the upper die.
7. Pull down the red handle again to complete the button-making process.
8. Finally, rotate the dies back to their original position and remove your finished button from the machine.
Remember to refer to the manual provided with your Mophorn Button Maker for any additional instructions or safety precautions.
Add New Comment