Answer

Mar 05, 2025 - 03:43 AM
To set up and use the Trend Worktop True Cut, please follow these steps:
1. Ensure you have the necessary tools: a 1/2" plunge router, a 30mm guide bush, a Trend 12mm thick worktop jig, and hand tools.
2. Make sure to read and understand the safety instructions provided in the manual, as well as the instructions for your power tool.
3. Position the worktop securely on trestles and clamp the worktop jig securely to the worktop at a comfortable height.
4. Insert the pins and push them up to the edge of the worktop. Place the Worktop True Cut into the jig slot as indicated and position it up to the post-formed edge.
5. Once the Worktop True Cut touches the worktop edge, gently tighten the handle. Remove the pins and/or cams.
6. Measure the gap between the two front faces of the male and female pieces of the worktop joint. Clamp the Worktop True Cut to your worktop jig.
7. Select the relevant cams and pins for the desired inset. Take measurements from step 6 and transfer them to the male piece of the worktop, factoring in the guide bush and cutter distance.
8. Place the jig onto the worktop and pivot it so that it follows your cut line.
9. Remove the pins and cams, pivot the jig to the offset scribe line on the marked worktop, and clamp the jig in position. Remove the Worktop True Cut device.
10. Begin the cut, following the routing instructions provided in the manual.
Please note that these are general instructions, and it is important to refer to the specific instructions provided in the manual for your Trend Worktop True Cut for more detailed and accurate guidance.
Add New Comment