How do I install the SUNCO Selectable Retrofit LED Light? (Sunco Selectable Retrofit LED Light Installation Guide)

Answer

manuals.plus

Mar 05, 2025 - 03:42 AM

Installation of the SUNCO DL_SMDR4-11W-27K_5K-#PK 4 Inch Selectable Retrofit LED Light is relatively simple. Here are the steps to follow:

1. Turn off the power: Before starting the installation, make sure to turn off the power to the existing recessed can where you will be installing the retrofit light. This can be done by switching off the circuit breaker or removing the fuse.

2. Remove the existing bulb: Remove the existing bulb from the recessed can and set it aside.

3. Adjust the color temperature: On the back of the retrofit light, you will find a switch that allows you to select the desired color temperature. Choose from the available options (2700K, 3000K, 3500K, 4000K, 5000K) based on your preference.

4. Attach the retrofit light: Insert the retrofit light into the recessed can, ensuring that it is properly aligned. The light should fit snugly into the can.

5. Connect the wires: Connect the wires from the retrofit light to the corresponding wires in the recessed can. Match the black wire to black, white wire to white, and green wire to green (or copper) wire. Use wire nuts to secure the connections.

6. Secure the retrofit light: Use the provided clips or springs to secure the retrofit light in place. Make sure it is firmly attached and does not move.

7. Restore power: Once the retrofit light is securely installed, restore power to the circuit by switching on the circuit breaker or replacing the fuse.

8. Test the light: Turn on the light switch and check if the retrofit light is functioning properly. If it doesn't turn on, double-check the wiring connections and ensure that the power is properly restored.

Please note that these instructions are a general guide. It is always recommended to refer to the specific installation guide provided by the manufacturer for detailed instructions and safety precautions.