User Manual Q&AAnswer
Mar 05, 2025 - 03:09 AM
To install the HINKLEY 53102 Brazos Point Wall Sconce, follow these steps:
1. Find a clear area in which you can work.
2. Unpack the fixture and glass from the carton.
3. Carefully review the instructions prior to assembly.
Mounting:
1. Remove the mounting plate (A) from the backplate (B) by removing the three screws (C).
2. Attach the mounting plate (A) to the junction box (J) with two screws (D), which are not provided.
3. Make all necessary electrical connections following the instruction sheet IS-18 provided.
4. After all connections are made, tuck the wires into the junction box (J) and slip the backplate (B) over the mounting plate (A), aligning the threaded holes in the plate with the holes (H) in the backplate (B).
5. Thread in the screws (C) that were removed earlier and tighten them to secure the fixture to the wall.
Glass Installation:
1. Place the glass (G) over the socket and turn it to lock it into place.
2. xxxx the glass cap (K) onto the glass (G).
3. Repeat the process for the other side of the fixture.
4. The fixture can now be powered on.
Wiring and Grounding Instructions:
- Read the wiring and grounding instructions (IS 18) and any additional directions.
- Turn off the power supply during installation.
- If new wiring is required, consult a qualified electrician or local authorities for code requirements.
Wiring Instructions:
Indoor Fixtures:
- Connect the positive supply wire (A) (typically black or the smooth, unmarked side of the two-conductor cord) to the positive fixture lead (B) using an appropriately sized twist-on connector.
- Connect the negative supply wire (C) (typically white or the ribbed, marked side of the two-conductor cord) to the negative fixture lead (D).
- Refer to the grounding instructions below to complete all electrical connections.
Outdoor Fixtures:
- Connect the positive supply wire (A) (typically black or the smooth, unmarked side of the two-conductor cord) to the positive fixture lead (B) using an appropriately sized twist-on connector.
- Connect the negative supply wire (C) (typically white or the ribbed, marked side of the two-conductor cord) to the negative fixture lead (D).
- Cover the open end of connectors with silicone sealant to form a watertight seal.
- If installing a wall mount fixture, use caulk to seal gaps between the fixture mounting plate (backplate) and the wall.
- Refer to the grounding instructions below to complete all electrical connections.
Grounding Instructions:
Flush Mount Fixtures:
- For positive grounding in a 3-wire electrical system, fasten the fixture ground wire (E) (typically copper or green plastic coated) to the fixture mounting strap (M) with the ground xxxx (S).
Chain Hung Fixtures:
- Loop the fixture ground wire (E) (typically copper or green plastic coated) under the head of the ground xxxx (S) on the fixture mounting strap (M) and connect the loose end of the fixture ground wire directly to the ground wire of the building system using appropriately sized twist-on connectors.
Post-Mount Fixtures:
- Connect the fixture ground wire (E) (typically copper or green plastic coated) to the power supply ground with an appropriately sized twist-on connector inside the post.
- Cover the open end of the connector with silicone sealant to form a watertight seal.
For further assistance or clarification, you can contact HINKLEY at:
HINKLEY 33000 Pin Oak Parkway,
Avon Lake, OH 44012
800.446.5539
440.653.5500
hinkley.com
Add New Comment