User Manual Q&AAnswer
Mar 05, 2025 - 02:35 AM
To install the FISHER PAYKEL AHV2RD84 Professional Square Handle Kit for Integrated Column Refrigerator or Freezer, please follow the steps below:
1. Ensure that you have the necessary tools for installation, including a screwdriver and measuring tape.
2. Start by removing any existing handles or trim from the refrigerator or freezer door.
3. Measure and mark the desired height for the handle on the door. The height of the handle should be 1 3/8 inches.
4. Measure and mark the center point of the door width. The width of the handle is 33 9/16 inches.
5. Align the handle with the marked center point and height on the door.
6. Secure the handle to the door using the provided screws. Make sure to tighten the screws securely, but avoid over-tightening to prevent damage to the handle or door.
7. Repeat the above steps for the other door if you have a pair of doors.
8. Once the handle is securely installed, check for any alignment issues or loose screws. Adjust as necessary.
Please note that these instructions are a general guideline, and it is always recommended to refer to the user guide or installation manual that comes with the product for specific instructions and any additional steps or precautions.
Add New Comment