User Manual Q&AAnswer
Mar 05, 2025 - 02:23 AM
To install the MONDOLUX MD68 Venosa Mini Wall Washer, please follow these steps:
1. Ensure that the mains power is turned off before starting the installation process.
2. Cut the required holes in the ceiling, taking into consideration the minimum space requirements between the fitting and the driver. Refer to Picture 1 in the instruction manual for visual guidance.
3. Pass the driver power supply wires through the cutout and plug them into a mains socket.
4. Connect the driver to the light fitting using the quick connector. Refer to Picture 2 in the instruction manual for reference.
5. Mount the fitting into the ceiling and secure it using the spring clips provided.
6. Switch on the mains power. Once completed, the installation is finished. Refer to Picture 3 in the instruction manual for visual confirmation.
Please note the following additional points mentioned in the manual:
- The fitting requires a power input of 220-240V AC/50Hz to the driver.
- Do not interchange any parts of the fitting.
- It is recommended to leave a minimum space of 75mm around the fitting for air ventilation to extend the product's lifetime.
- Maintain a minimum distance of 800mm between the fitting and the illuminated subject.
- Do not touch the fitting when it is in use.
- Avoid installing the fitting near any heat sources.
- Do not install any inductive loads, such as exhaust fans, within the same lighting circuit as the current fitting. Issues caused by such connections will not be covered under the warranty policy.
If you have any further questions or concerns regarding the installation of this product, it is advised to contact Mondolux for assistance.
Add New Comment