Answer

Mar 05, 2025 - 01:41 AM
To set the date and time on the INTERMATIC ET2815CR Electronic 1-Circuit Astronomic 7-Day Time Switch, follow these steps:
1. Press the MODE button on the time switch until the SET and DATE icons appear at the top of the display. The month will start flashing.
2. Use the + or - buttons to select the current month, and then press ENTER/NEXT. The day of the month will start flashing.
3. Use the + or - buttons to select the current day of the month, and then press ENTER/NEXT. The year will start flashing.
4. Use the + or - buttons to enter the current year, and then press ENTER/NEXT. The month will start flashing again.
5. Press the MODE button to move to the next mode selection.
To set the time on the time switch, follow these steps:
1. Press the MODE button until the Set Clock mode selection is active. The SET and TIME icons will appear on the display, and a flashing 12:00 AM will be displayed (if the clock has not been set).
2. Use the + or - buttons to select the current time. Note that you can set the seconds to 00 by pressing ENTER/NEXT.
3. Press the MODE button to save the time and move to the Enable Daylight Saving Time mode selection.
After setting the date and time, you can proceed with programming the time switch according to your needs. For more detailed instructions and information, please refer to the INTERMATIC ET2815CR Electronic 1-Circuit Astronomic 7-Day Time Switch Instruction Manual.
Add New Comment