How do I install the Maxxima MRL-62200BC 6-8 Inch Commercial Downlight? (Maxxima MRL-62200BC 8 Inch Commercial Downlight Installation Guide)

Answer

manuals.plus

Mar 04, 2025 - 11:26 PM

To install the Maxxima MRL-62200BC 6-8 Inch Commercial Downlight, please follow the steps outlined in the installation guide provided:

1. Ensure that the power to the fixture has been disconnected before starting the installation.
2. Remove the existing fixture and trim.
3. Open the J-box and disconnect all wires connected to the fixture.
4. Attach the carabiner safety clip from the new fixture to the existing fixture housing.
5. Insert the lamp conduit into the J-box and wire it to the power source (black to hot, white to neutral, green to ground). If using a dimmer, connect the purple wire to the "+" and the gray wire to the "-".
6. Adjust the lamp power to the desired lumen output and CCT by sliding the selector switches on top of the fixture housing.
7. Squeeze the two housing clips so they are in an upright position and insert the lamp into the housing.
8. Once the lamp is inside the housing, release the housing clips and continue pushing the lamp into the housing until it is securely fixed and flush with the ceiling.

For new construction installation, follow these additional steps:

1. Make sure the power is turned off at the source.
2. Determine the location for installation and cut a ceiling hole with an approximate diameter as stated in the commercial downlight housing compatibility table.
3. Attach the carabiner safety clip to a secure place inside the ceiling.
4. Insert the lamp conduit into the J-box and wire it to the power source (black to hot, white to neutral, green to ground). If using a dimmer, connect the purple wire to the "+" and the gray wire to the "-".
5. Adjust the lamp power to the desired lumen output and CCT by sliding the selector switches on top of the fixture housing.
6. Squeeze the two housing clips so they are in an upright position and insert the lamp into the ceiling.
7. Once the lamp is inside the ceiling, release the housing clips and continue pushing the lamp into the ceiling until it is securely fixed and flush.

Please note that the installation should be performed by a qualified electrician in accordance with the National Electrical Code and relevant local code. It is important to read and follow all product labels and instructions before installing the fixture to ensure safety and proper installation.