User Manual Q&AAnswer
Mar 04, 2025 - 11:04 PM
To install the Select Blinds Roller Shades with Cassette, you will need to follow these steps:
1. Fitting the Brackets:
- There are two methods of installation for the brackets:
- Use the front two holes in the top of the bracket to fix it to the lintel (the 'ceiling' of the recess).
- Use two screws through the back plate to mount it onto a facing surface (a wall or window frame).
- Ensure that the outermost brackets are positioned at least 5cm away from the ends of the rail, and distribute any other brackets evenly across the width.
2. Fitting the Shade:
- Hold the rail at an angle and place the T-shaped lip on the top of the cassette into the front lip of the bracket.
- Twist the back of the cassette upwards until it snaps into place against the back lip of the bracket.
Before starting the installation, please note the following:
- We will have positioned the controls as per your request during the ordering process. However, if you need to swap the side they are on, change the direction of the roll, or trim the blind further, you can remove the controls by unplugging them from the tube. This should be done before fixing the brackets.
Additional Information:
- The brackets offer three methods of installation: screwing into the lintel, screwing onto a facing surface, or screwing into the side walls of the recess.
- Top-fixing or face-fixing is recommended for most installations, while side-fixing is only recommended if the width measurement was taken right at the top of the recess.
3. Fitting the Blind:
- Locate the depression end (opposite end to the controls) of the blind and insert it into the cross-shaped hole in the corresponding bracket.
- Lift the control end of the blind and insert the rectangular 'lugs' into the corresponding slots on the bracket.
Please refer to the Select Blinds Roller Shades with Cassette Installation Guide for more detailed instructions and illustrations.
Add New Comment