User Manual Q&AAnswer
Mar 04, 2025 - 10:32 PM
To install the Cisco PWR-C1-1100WAC Power Supply, follow these steps:
1. Turn off the power at its source.
2. Remove the power cord from the power cord retainer.
3. Remove the power cord from the power connector.
4. Press the release latch at the right side of the power supply module inward and slide the power supply out.
- Caution: Do not leave the power-supply slot open for more than 90 seconds while the switch is operating.
5. Insert the new power supply into the power supply slot, and gently push it into the slot.
- Note: The 350 W and 715 W power supplies (excluding the power cord retainer) should be flush with the switch rear panel when correctly inserted.
6. (Optional) Make a loop in the power cord and thread it through the power cord retainer or use the cable-tie retainer clip on the 1900 W supply.
7. Connect the power cord to the power supply and to an AC power outlet. Turn on the power at the power source.
8. Confirm that the power supply AC OK and PS OK LEDs are green.
Please refer to the Cisco PWR-C1-1100WAC Power Supply Installation Guide for more detailed instructions and illustrations.
Add New Comment