User Manual Q&AAnswer
Mar 04, 2025 - 10:29 PM
To adjust the length of the positioning belt, follow these steps:
1. Loosen or tighten the unsecured belt end on each side of the buckle.
2. Both sides of the belt should be of equal length.
3. The fit must be snug, but not so tight that comfort or breathing is compromised.
4. You should be able to slide your open hand between the belt and the wheelchair user.
Please note that the positioning belt should be properly adjusted and the mounting bolts securely installed before use. Refer to step 3 in the installation instructions for more information.
(Source: Everst and Jennings PT300-505 Positioning Belt Push Button System Instruction Manual)
Source: Everst and Jennings ,PT300-505, Positioning Belt Push Button System, Instruction Manual
Add New Comment