Answer

Mar 04, 2025 - 09:38 PM
To select the module address for the Shinko QMC1-C Communication Expansion Module, follow these steps:
1. Locate the module address selection rotary switch on the module.
2. Use a small flat-blade screwdriver to select the module address.
3. For the QMC1- -0 [Console selection (MODBUS RTU/SIF)], the value obtained by adding 1 to the value of the selected rotary switch becomes the module address. The module address ranges from 0 to F (1 to 16).
4. For the QMC1- -1 (C series compatible), the value of the selected rotary switch becomes the module address. The module address ranges from 0 to F (0 to 15).
Note: The module address selection is required to communicate with the host computer or PLC. Make sure to select a unique module address for each module connected in the system.
Add New Comment