User Manual Q&AAnswer
Mar 04, 2025 - 08:28 PM
To install the Anolis Ambiane HP111 Pendant Remote, follow these steps:
1. Ensure that the unit is installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations.
2. The unit is designed for indoor use only, so make sure to install it in an indoor location.
3. Do not install the unit near highly inflammable liquids or materials.
4. Ensure that nothing rests on the unit.
5. Keep the unit away from open flames.
6. Install the unit in a clean, dust-free, and well-ventilated location.
7. Avoid looking directly into the light beam at close range.
8. Make sure that the ceiling or structure intended for installation can safely hold at least 5 times the weight of the unit.
9. Check the immunity and emission standards of the equipment before installing it.
10. Install the control unit on the ceiling using the provided holes in the housing.
11. Fasten the ceiling plate to the lower ceiling.
12. xxxx the spherical cap with the hanging wire to the ceiling plate.
13. Drill a hole in the lower ceiling for the LED unit supply cable. If you want the cable to be parallel to the hanging wire, maintain a distance of 34mm between them.
14. Secure the LED unit supply cable above the ceiling to prevent it from loosening.
15. Install the terminal block on the supply cable and connect it to the control unit's PCB.
16. Install the terminal block on the DMX cable and connect it to the control unit's PCB.
17. Install the terminal block on the LED unit cable and connect it to the control unit's PCB.
18. Install any additional terminal blocks on cables as required for your installation.
19. Set the desired position of the LED unit using the hanging wire. Press and hold the wire lock to pull the wire out if needed.
20. Use the three locks on the hanging wires to align the LED unit if necessary.
21. Snap the Ring Louver to the LED unit.
22. Set the DIP switch on the control unit according to your operation mode. The DIP switch is accessible through an aperture in the cover of the control unit.
23. The fixture can be controlled using DMX 512, DALI, or 0-10V methods. Connect the fixture to the appropriate control system.
24. Set the DMX or DALI address of the fixture using an external controller.
25. If using DMX control, set the DMX start address on the control PCB using the DIP switch or RDM.
26. The fixture supports RDM operation, allowing you to set various parameters and perform software updates.
27. Refer to the manual for detailed information on DMX protocols and control settings.
28. Ensure that the fixture is connected to a compatible power supply.
29. Follow the recommended maintenance and cleaning procedures for the fixture.
30. Dispose of the product properly at the end of its life according to local regulations and codes.
Please refer to the Anolis Ambiane HP111 Pendant Remote User Manual for more detailed instructions and safety information.
Add New Comment