Answer

Mar 04, 2025 - 08:02 PM
To adjust the blend ratio on the Darkglass Electronics B1K CMOS Bass Overdrive Pedal, you need to use the Blend control located on the back of the pedal. The Blend control allows you to mix the clean input signal with the overdriven signal. The clean signal is fixed at unity gain, while the volume of the overdriven signal is set by the Level xxxx on the front of the pedal.
To adjust the blend ratio, turn the Blend control clockwise to blend in more of the clean signal, or counterclockwise to blend in more of the overdriven signal. This gives you fine control over the balance between the clean and overdriven tones.
It's important to note that the Blend control is located on the back of the pedal, so you will need to open the magnetic bottom lid to access it.
Add New Comment