User Manual Q&AAnswer
Mar 04, 2025 - 07:16 PM
To switch the SYNUS/2 radio remote control between Fixed Code mode and Rolling Code mode, follow these steps:
1. Press and hold both keys A and B simultaneously.
2. After a few flashes, the LED will light up with a steady RED light.
3. Continue to hold both keys A and B.
4. After 5 seconds, the LED will change to GREEN, indicating that the Rolling Code mode is active.
To switch back to Fixed Code mode, repeat the same procedure. The LED should change from GREEN to RED.
Please note that in the case of transmitting a cloned code, the LED will alternate between RED and GREEN. The fast flash of the RED LED indicates that the Fixed Code mode is enabled, while the fast flash of the GREEN LED indicates that the Rolling Code mode is enabled.
For more information and detailed instructions, please refer to the "Operating mode selection" section in the ROGER SYNUS/2 Radiocomando Radio Trasmitter Instruction Manual.
Add New Comment