User Manual Q&AAnswer
Mar 04, 2025 - 11:37 AM
To install the Sylvan SL40E Smart Entry Lever Handle Latch Lock, follow these steps:
1. Turn the handle: Adjust the handle according to the direction you open the door. For the front panel, loosen the screws and open the handle toward the left or right. Reinstall the xxxx after adjusting the direction. Repeat the same process for the back panel.
2. Install Mortise: Install the mortise according to the provided diagram.
3. Install Sliding xxxx Casing: The xxxx casing place is adjustable from 55mm to 100mm far from the square shaft. Depending on the location of the hole drilling or the old door hole, adjust the xxxx casing. Make sure the arrow on the casing is pointing down.
4. Install back gasket: Install the back gasket provided.
5. Install Back Panel and link: Install the back panel and link it to the mortise.
6. Install battery and back cover: Insert 4 x AA alkaline batteries into the lock. Make sure to use alkaline batteries and not lithium batteries. Then, install the back cover.
7. Installation complete: Your Sylvan SL40E Smart Entry Lever Handle Latch Lock is now installed and ready to use.
For more detailed instructions and illustrations, please refer to the user manual provided with the .
Add New Comment