User Manual Q&AAnswer
Mar 04, 2025 - 11:35 AM
To ensure the safety of using the Trend router cutter, please follow these guidelines:
1. Disconnect the machine from the power source before making any adjustments.
2. Wear appropriate Personal Protection Equipment (PPE) for eye, ear, and respiratory protection.
3. Keep your hands, hair, and clothing clear of the cutter.
4. Before each use, check that the cutting tool is sharp and free from damage. Do not use the cutting tool if it is dull, broken, cracked, or damaged.
5. Clean the clamping surfaces to remove dirt, grease, oil, and water.
6. Insert the tool's shank into the router's collet until the K mark is at least partially or fully covered by the collet.
7. Ensure that tools and tool bodies are clamped securely to prevent them from becoming loose during operation.
8. Take care when mounting cutting tools to ensure that the clamping is done by the shank of the cutting tool and that the cutting edges are not in contact with each other or with the clamping elements.
9. Tighten fastening screws and nuts using the appropriate spanners to the torque value provided by the manufacturer. Do not use extension or hammer blows for tightening.
10. Tighten clamping screws according to the manufacturer's instructions. If instructions are not provided, tighten clamping screws in sequence from the center outwards.
11. Always wear eye protection.
12. If excessive vibrations occur while using the router, stop the operation immediately and have the eccentricity of the router cutter and clamping system checked by competent personnel.
13. Do not exceed the maximum speed marked on the tool or shown in the chart or packaging. Adhere to the stated speed range if provided.
14. Follow the manufacturer's instructions for tool repair and maintenance. Repair composite tools only in accordance with the manufacturer's instructions and without changing the design.
15. Take care to maintain tolerances that ensure correct clamping during repair.
16. Ensure that regrinding of the cutting edge does not weaken the body and the connection of the cutting edge to the body.
17. Recycle raw materials instead of disposing of them as waste.
18. Sort packaging for environmentally-friendly recycling.
19. Guarantee: All Trend products are guaranteed against defects in workmanship or material, except for products damaged due to improper use or maintenance.
For more information and specific details, please refer to the Trend Router Cutter Safety Instructions manual provided with the product.
Add New Comment