User Manual Q&AAnswer
Mar 04, 2025 - 07:10 AM
Installation of the ISO 560943 Wall Mount Door Holder is relatively straightforward. Here is a step-by-step guide:
1. Determine the location: Choose a suitable location on the wall where you want to mount the door holder. Ensure it is within reach and easily accessible.
2. Mark the holes: Hold the door holder against the wall and use a pencil or marker to mark the positions of the xxxx holes on the wall.
3. Drill pilot holes: Using an appropriate drill bit, drill pilot holes at the marked positions on the wall. Make sure the holes are deep enough to securely hold the screws.
4. Mount the door holder: Align the xxxx holes on the door holder with the pilot holes on the wall. Insert the screws through the holes and tighten them using a screwdriver or drill. Ensure the door holder is securely attached to the wall.
5. Connect the wires: Connect the red wire to the positive (+) terminal of the power supply and the black wire to the negative (-) terminal. This will provide power to the door holder.
6. Test the door holder: Press the emergency release button or test button to ensure that the door holder is functioning properly. The door should release when the button is pressed.
7. Optional manual door release button: If you have the optional manual door release button, you can connect it to the door holder according to the provided instructions. This button allows for manual release of the door in case of an emergency.
It is important to follow the instructions provided in the manual for proper installation and usage of the ISO 560943 Wall Mount Door Holder. If you encounter any difficulties or have further questions, you can contact the manufacturer's customer support at the provided phone number or email address.
Add New Comment