User Manual Q&AAnswer
Mar 04, 2025 - 07:00 AM
To change the working mode and adjust the brightness of the LUMENA Hiway MAX 40W PIR Solar Street Light, you can use either the main power button on the lamp or the remote control.
Using the main power button on the lamp:
1. Press the main power button once to turn on the lamp.
2. Press the button again to switch to Mode A - Constant Lighting. In this mode, the light will stay on for a selected time (2hr, 4hr, 6hr, 8hr, 10hr, or 12hr) at a selected brightness level (60%, 80%, or 100%).
3. Press the button a third time to switch to Mode B - Motion Sensor Mode. In this mode, the light will stay at 30% brightness constantly from dusk. When motion is detected within 12m, the brightness will increase to the selected level for approximately 20 seconds.
4. Press the button a fourth time to turn off the lamp. Please note that the remote control will not work if the lamp is switched off using the main power button.
Using the remote control:
1. Press the main power button on the lamp once to turn on the lamp.
2. Use the remote control to change the working mode and adjust the brightness.
- For Mode A - Constant Lighting Mode: Press the "Constant Lighting Mode" button, then press the desired "Time" button (2hr, 4hr, 6hr, 8hr, 10hr, or 12hr), and finally press the desired "Brightness" button (60%, 80%, or 100%).
- For Mode B - Motion Sensor Mode: Press the "Sensor Mode" button, and then press the desired "Brightness" button (60%, 80%, or 100%).
3. The lamp will remember the last setting as the new default. It will continue in the latest default working mode with every new lamp cycle. If the lamp is manually turned off using the button, it will return to the original default setting when turned back on.
Please refer to the user manual for more information and detailed instructions on the installation, maintenance, and other features of the LUMENA Hiway MAX 40W PIR Solar Street Light.
Add New Comment