How do I install the Tribesigns Walnut Incandescent Semi-flush Mount Light? (TRIBESIGNS Walnut Incandescent Semi-Flush Mount Light Instruction Manual)

Answer

manuals.plus

Mar 04, 2025 - 03:46 AM


To install the Tribesigns TH-SF0202 Walnut Incandescent Semi-flush Mount Light, please follow these steps:

1. Before starting the installation, make sure to turn off the electrical power to the area where you will be installing the light fixture.

2. Ensure that you have all the necessary wiring supplies required by your local electrical code.

3. Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have occurred during shipping. If there is any defect in the wire, do not attempt installation.

4. The fixture can be assembled using the parts included in the package. Refer to the provided code and part description to identify the required parts.

5. Start by attaching the single mounting bracket (part C) to the junction box (part A) using the provided nuts (part E).

6. Next, attach the canopy (part F) to the single mounting bracket using the provided nuts (part E).

7. Connect the Ø5 8"-3.9" rods (part G) to the bracket (part H) and attach them to the canopy.

8. Connect the Ø1/2"-2.8" rods (part J) to the lamp holder (part K) and attach them to the bracket.

9. Attach the pipe rings (part L) to the rods (part J) and secure them with the provided nuts (part N).

10. Connect the Ø3/8"-6" rods (part M) to the pipe rings (part L) and secure them with the provided nuts (part N).

11. Finally, connect the fixture wires (part P) to the corresponding wires in your electrical box, following the applicable installation code. Make sure to secure the connections properly.

12. Once the installation is complete, turn on the electrical power and test the light fixture.

Please note that this product is rated for up to a 60-watt maximum TYPE A bulb or a 13-watt compact fluorescent light bulb or a 9-watt LED bulb. Do not exceed the recommended wattage to avoid the risk of fire.

For cleaning the fixture, turn off the power, wait for it to cool, and wipe it with a clean, soft cloth. Avoid spraying cleaner directly onto the fixture.

For any further troubleshooting or specific inquiries, please refer to the provided instruction manual or contact the manufacturer's customer support.