User Manual Q&AAnswer
Mar 04, 2025 - 03:21 AM
To install the killerbody 48766 LED Light System with Control Box, please follow these steps:
1. Pre-check the proper fixture location: Before using the 3M double-sided tape to fix the LED lights, make sure to determine the best location for the lights. Due to the limited wire length of the LED lights set, it is important to choose a location that allows for easy connection to the control box.
2. Fix the LED lights set: Use the provided 3M double-sided tape to securely fix the LED lights set in the chosen location. It is recommended to fix the LED lights set at the nearest area to the signal receiver, which is located on the bottom of the chassis.
3. Connect the LED lights to the control box: Connect the LED lights to the control box using the provided wires. The control box has specific ports for different functions:
- Ports 1/2/3/4 on the box are for FORWARD.
- Ports 5/6 on the box are for BACKWARD.
- Ports L/R on the box are for TURN L/R.
4. Power on the LED light control system: Once the LED lights are properly connected to the control box, connect the power source to the control box. The red indicator light on the control box will light up, indicating that the LED light control system is powered on.
5. Using the remote controller: The remote controller has specific functions for controlling the LED lights:
- To turn on all lights, keep turning the remote controller to the left (L) for over 10 seconds.
- To turn off all lights, keep turning the remote controller to the right (R) for over 10 seconds.
- If there is no control input for over 10 seconds, all lights will flash. When receiving any signals, all lights will light up dimly.
6. Selecting light modes: The control box offers two light modes:
- "A" light mode is the normal cars light mode.
- "B" light mode is the keeping flashing mode.
Please refer to the provided manual for further details and troubleshooting tips.
Add New Comment