Answer

Mar 04, 2025 - 02:48 AM
To assemble the GAINSBOROUGH K920 5ft Spiral LED Christmas Tree, please follow these steps:
Step 1: Assemble the plastic tree stand by following the instructions shown in Figure 1.
Step 2: Insert the lower trunk into the tree stand, as shown in Figure 2.
Step 3: Insert the upper part of the trunk into the top of the spiral tree frame. Carefully lift up the spiral tree and topper by holding the upper trunk.
Step 4: Insert the upper part of the trunk into the lower part of the trunk slowly, allowing the spiral tree frame to cascade downwards over the lower trunk.
Step 5: Finally, use the plastic tree stand and clip it to the spiral tree frame to secure.
For outdoor use, you can secure the tree to the ground by firmly pushing three stakes through the holes of the plastic tree stand into the ground.
Please refer to the instruction manual for visual illustrations and additional information.
Note: Always ensure that the item is fully assembled and the light strings are properly connected before switching it on.
Add New Comment