User Manual Q&AAnswer
Mar 04, 2025 - 02:13 AM
To install and set up the TIMETRAX PPDLAUBKN Proximity Time Clock System, follow these steps:
1. Connect the terminal:
- Connect one end of the RJ45 cable into the "ETHERNET" port located on the back of the time clock terminal.
- Connect the power supply into the "POWER" port located in the compartment on the back of the terminal.
- Route the cables through the channel at the base of the terminal.
- Mount the terminal using the provided mounting hardware.
- Plug the free end of the RJ45 cable into a DHCP network jack, router, or switch.
- Plug the power supply into an outlet.
2. Download the TimeTrax™ Software:
- Open your web browser and go to pyramidtimesystems.com/V5.
- Scroll down to the "DESCRIPTION" tab and follow the instructions to download the software.
- Once the software is installed, use the default login information: Login ID: ADMIN, Password: PTI.
- After logging in, navigate to CLOCK/HARDWARE MANAGER and ensure that your clock is shown as "ONLINE" under STATUS.
- Put a checkmark in the ACTIVE box to claim your clock and allow for automatic punch downloads. If your device is offline, check your connections.
3. Mount the terminal:
- Install the mounting bracket using the provided screws and drill template. Ensure that the "TOP" is engraved correctly and the tabs face upward.
- Push the terminal onto the mounting bracket, aligning the four tabs on the bracket with the four matching slots on the back of the terminal. Note down the terminal serial number before mounting.
- Slide the terminal downward until the locking tab clicks into place. Once properly mounted, the terminal cannot be removed from the bracket without using the included wall bracket release key to disengage the locking tab.
- Route the cables through the channel at the base of the terminal or drill a hole in the rectangular section of the mounting bracket and through the wall to conceal the cables.
To detach the terminal:
- Insert the key (tab facing outward) into the narrow slot located on the bottom of the terminal, to the right of the cable access cutout.
- Push the key all the way up into the slot. The key will slide easily until the last ½ inch, where some resistance from the locking tab is felt.
- With the key fully pushed into the slot, slide the terminal up and off the mounting bracket.
4. Using the Time Clock:
- Wave the proximity badge within two inches of the target area on the time clock terminal.
- If the employee badge number is successfully read, the terminal will beep, and the badge number will be displayed briefly on the terminal screen.
For further technical support and warranty information, visit pyramidtimesystems.com/support/warranty-and-return.
Add New Comment